Before Installing The Eyebeam Softphone; Installing And Configuring An Eyebeam Sip Softphone - Toshiba Strata CS User Manual

Before installing the eyeBeam softphone_____________________

Before installing an eyeBeam SIP softphone on your computer, talk to your system
administrator and make sure you know the following:
The IP address or name of the Strata CS SIP span.
!
The preferred codec(s), in order, of the Strata CS SIP span, for example, G.711.
!
The authentication username and password required, if any.
!
Whether or not you have an external station. See the next section.
!
If you have an external station
If you have an external station, you must configure it for a SIP phone before you can use the
eyeBeam softphone. See "Configuring a SIP phone" on page 6-14 for instructions.
If you don't have an external station
If you don't have an external station, choose
Imitate a station when my incoming routing calls to external numbers

Installing and configuring an eyeBeam SIP softphone __________

Use this procedure to install an eyeBeam softphone on your PC and configure it for use with
Strata CS.
Notes
These procedures describe the eyeBeam audio-only softphone version 1.1 3004w or
!
higher. It is recommended that you have the eyeBeam User's Manual available as you
install the softphone.
The configuration procedure describes only those steps necessary for the eyeBeam
!
phone to work with Strata CS. Other settings may be left in their default configuration. For
information on using other eyeBeam features, see the eyeBeam documentation.
A G. U
PPENDIX SING THE EYE
B SIP
EAM SOFTPHONE
, click the Phone tab, and check
Tools > Options
.
G-3