Adjusting Network Setting; Setting Serial Port Baud Rate; Enabling Serial Port Echo; Setting Serial Port Path - Christie D13WU2-HS User Manual

Adjusting network setting

Set up network configuration setting, such as reset back to default.
1. Select Menu > Configuration > Communications > Network.
2. Set up the appropriate network setting:
• Show Network Message—Enable or disable to display of the network message.
• Reset to Default—Reset the network configuration setting, including LAN setting and
WLAN setting, back to default.
3. To apply the network configuration, press ENTER.

Setting serial port baud rate

Select the serial port and baud rate.
1. Select Menu > Configuration > Communications > Serial Port Baud rate.
2. Set up the appropriate baud rate.
3. To confirm the selection, press ENTER.

Enabling serial port echo

Enable or disable to allow the CLI command pass through.
1. Select Menu > Configuration > Communications > Serial Port Echo.
2. To swap, press ENTER.

Setting serial port path

Set the serial port path to allow the command pass through RS232 or HDBaseT.
1. Select Menu > Configuration > Communications > Serial Port Path.
2. Select the appropriate serial port path.
3. To confirm the selection, press ENTER.
HS Series 2K User Manual — D13HD2-HS, D13WU2-HS, D16HD-HS, D16WU-HS, D20HD-HS, D20WU-HS
020-001466-06 Rev. 1 (12-2022)
Copyright ©2022 Christie Digital Systems USA Inc. All rights reserved.
Configuring communications
55