Epson Stylus Pro 9500 Service Manual page 91

EPSON Stylus Pro 9500
LOWER PAPER GUIDE REMOVAL
When removing/installing the Lower Paper Guide, the
following adjustment procedure is required.
n Adjust the paper guide L installation position.
Refer to page 204
n Check the paper cutting position. Refer to
Adjust the cutter mounting position in accordance with
the results of the paper cutting position check, then
adjust the CR cover height. Refer to page 205,page 143.
1. Remove the Maintenance Cover.(See 4.2.1.1)
2. Open the Front Cover, and remove the eight screws (CP(W2) M3x6)
securing the Lower Paper Guide.
CP(W2) M3x6
Figure 4-11. Location of Lower Paper Guide Screws
Disassembly & Assembly
3.
4. While supporting the Front Cover with your hands, lower the Lower Paper
page 207
Right cover holder
Disassembly Flow
Remove the screw used to fasten the right cover holder assembly,
then remove the right cover holder.
Guide as shown below.
n
You may find it useful or necessary to move the Front
Cover up/down while removing the Lower Paper Guide.
n
To avoid interfering with the P-Front sensor, pull the top
out towards you as you lower the Lower Paper Guide.
Lower Paper Guide
Figure 4-12. Lower Paper Guide Removal
Revision A
91