Self-Diagnostics - Epson Stylus Pro 9500 Service Manual

EPSON Stylus Pro 9500

5.2.3 Self-Diagnostics

This section gives detailed descriptions of the items in Table 5-2, "Service
Parts & Required Adjustments," on page 158.
5.2.3.1 Entering Self-Diagnostic Mode
1. Push down the Release Lever to the Lock position.
2. Press the following buttons on the Control Panel while turning on the
printer.
Paper Feed + Cut/Eject + Cleaning
3. When "Check: Test" appears on the LCD, the printer has entered the Self-
Diagnostic mode.
Use the Control Panel buttons to activate a Self-Diagnostic function, as
described in the table below.
Table 5-3. Self-Diagnostic Mode Controls
Normal Self-Diagnostic
Function Function
Pause Return up one
level
SelecType Next menu
Paper Source Previous menu
+ Next item or value
(Paper Feed
- Previous item or
(Paper Feed value
Cut/Eject Enter
To exit the Self-Diagnostic mode, turn off the printer.
Adjustment
Meaning
Moves up one level (without selecting at item).
Displays the next menu.
Displays the previous menu.
Displays the next item or increases the value
of the item shown on the LCD.
Displays the previous item or decreases the
value of the item shown on the LCD.
Selects/activates the item.
Figure 5-1. Self-Diagnostic Controls
Adjustment Steps
Operate
Pause To next or
previous
Reset
3 sec.
Ink Out
K C M LC LM Y
Paper Out
SelecType
To next or
Paper Source
Roll
Auto Cut
Item
Roll
+
Cutter Off
Paper Feed
Sheet
_
Cut /Eject
Enter
Cleaning
Power
3 sec.
Revision A
menu
previous
menu
To next or
previous
item
Selects or
activates
the item
166