Epson Stylus Pro 9500 Service Manual page 202

EPSON Stylus Pro 9500
o Counter Initialization Menu
The items that can be initialized in the "Counter Initialization Menu" in
Maintenance Mode 2 are shown below.
Table 5-17. Counter Initialization Menu
Item
Initializes NVRAM / Ink System /
Mechanism Counters.
Initializes NVRAM contents (Panel
setting information, Bi-D and Cap
Adjustment parameters).
Timer Setting Value Initialization
CR Motor Service Life Counter
Initialization
PF Motor Service Life Counter
Initialization
Head Unit Service Life Counter
Initialization
Cleaning Unit Service Life Counter
Initialization
Total Printed Page Count Counter
Initialization
Ink Level Counter Initialization
Waste Ink Capacity Counter Initialization
Adjustment
Panel Display Setting Value
INIT.ALL EXEC.
INIT.NVRAM EXEC.
INIT.TIMER EXEC.
INIT.CR MTR EXEC.
INIT.PF MTR EXEC.
INIT.HEAD EXEC.
INIT.CLEANER EXEC.
INIT.TTL PR EXEC.
INIT.INK EXEC.
INIT.WA INK EXEC.
Adjustment Steps
o Adjustment Menu
The items that can be initialized in the Counter Initialization Menu in
Maintenance Mode 2 are shown below.
Table 1-35 List of Adjustment Menu Items
Table 5-18.
Item
Right Head Bi-D Offset Setting#1
\(Normal dot) Note 2)
Ink Level Detection Note 3)
MW 2 Feed Balance Note 4)
Note 1): Settings with underlines show default values.
Note 2): This sets the desired offset the adjustment value in Bi-D Adjustment
Pattern #3, set by the user. This mode is a function for reducing
irregular color that occurs in the 720 dpi x 720 dpi and 1440 dpi x 720
dpi printing modes due to setting of the desired offset with respect to
the adjustment values for Bi-D adjustment values (Bi-D adjustment
pattern No. #3) for these printing modes. However, since there are
cases where there is no effect even when the desired offset is set in
this function, adequate caution should be exercised when changing
the setting values.
Note 3): This sets whether the sensor which detects the I/C type identifier on
the I/C label will detect it or not.
Note 4): If microbanding, which occurs in the 720 x 360 dpi mode and the 720
x 720 dpi mode actually occurs, this reduction function acts to reduce
banding somewhat when this setting is changed. However, there may
not be any effect even if the setting is set in the desired value by this
function, so exercise caution when changing the setting value.
Revision A
Panel Display Setting Value
BID OFFSET #1 -4~0~4
ON
DET.ECT INK LABEL
OFF
MW 7 BALANCE -31~0~+31
202