Epson Stylus Pro 9500 Service Manual page 38

EPSON Stylus Pro 9500
Note 2): During HEX dump execution, the message "HEX MODE" is
displayed.
Note 3): If you are using the Stylus Pro 7000 to print in the single color mode
at 720 x 720 dpi, if banding is prominent, selecting this mode may
possibly reduce banding.
Product Description
MAINTENANCE MODE 2
o
Start Button:Turn the Power switch On while pressing the following panel
buttons to start.
n
"Paper Source Button" + "Cut / Eject Button" + "Paper Feed –
Button"
o
Setting Item Selection:"Paper Source" Button
o
Changing Setting Values:"Setting Value +" or "Setting Value –" Button
o
Setting the Set Values:"Enter" Button
o
Setting End:Power ON/OFF
This mode can be roughly divided into the following 3 items.
Table 1-29. Maintenance Mode 2 Setting Items
Item
Counter Display Menu
Counter Initialization Menu
Adjustment, Setting Menu
For each major item, see the following page.
o
Counter Display Menu
The items displayed in the Maintenance Mode 2 "Counter Display Menu" are
shown below.
Table 1-30. Counter Display Menu
Item
Remaining Ink (K) counter
Value Display
Remaining Ink (C) counter
Value Display
Remaining Ink (M) counter
Value Display
Remaining Ink (LC) counter
Value Display
Control Panel
Panel Display
VIEW COUNTERS MENU
CLEAR COUNTERS MENU
SERVICE CONFIG MENU
Panel Display Setting Value
INK K 0~4294967295 (Decimal number)
INK C 0~4294967295 (Decimal number)
INK M 0~4294967295 (Decimal number)
INK LC 0~4294967295 (Decimal number)
Revision A
38