Epson Stylus Pro 9500 Service Manual page 100

EPSON Stylus Pro 9500
4.2.3.3 Removing the CR Motor/Pulley Assembly
1. Remove the L/R Side Covers.(See 4.2.1.3)
2. Manually release the Carriage Lock and move the carriage away from the
capping position.
3. On the Left Side Frame, find the CR Driven Pulley and loosen the two
screws securing it to the frame. Then loosen the tension on the steel belt.
Figure 4-24. CR Motor Removal & CR Steel Belt Loosening
When removing the CR Motor, the following adjustment
procedures are required.
n
CR Steel Belt Tension Adjustment.Refer to page 213
Disassembly & Assembly
4. Towards the right side of the frame there is one screw securing the steel
CR Driven pulley
Loosen these
two screws.
Disassembly Flow
belt, remove this screw. Then remove one edge of the steel belt, and finally
pull out the steel belt to the Right Side Frame.
Remove one Hex Screw:2.5mm
Figure 4-25. CR Motor Removal/Steel Belt Removal
Revision A
CR Steel Belt
100