Epson Stylus Pro 9500 Service Manual page 125

EPSON Stylus Pro 9500
7. After the cleaning sequence is completed, the message "Remove cleaning
jig" will be displayed in the LCD, so remove the 6cartridges of S46
transport liquid cartridge from the I/H assembly and lower the ink set lever.
8. Press the [Enter] button to start the transport liquid discharge sequence.
During execution of this sequence, the message "Head Cleaning" is
displayed in the LCD. This sequence discharges the S46 transport liquid
used to fill the ink supply system from the printer, and ends in
approximately 4 minutes.
9. When the transport liquid discharge sequence is completed, the message
"Adj: Counter Clear" will be displayed in the LCD. When the [Enter] button
is pressed, the message "Reset Counter?" will be displayed in the LCD.
By pressing the [Enter] button, the counters for the following items will be
reset. By executing this operation, initial filling will be done automatically
when the power is turned ON next.
n Ink cartridge consumption counter
n Waste ink pad counter
n Initial filling flag set
10. Turn the printer's power OFF, then pull the AC plug out of the AC outlet.
Disassembly & Assembly Disassembly Flow
Revision A
125