EPSON Stylus Pro 9500
SENSORS
This function allows you to confirm the sensors are operating properly. The
current status (ON or OFF) of the sensors (one at a time) is shown in the LCD
display, and you need to check the sensor operation by hand. For example, to
check the Release Lever position sensor, move the lever up and down.
[Pause] returns you
to previous menu
[SelecType]
Sen: CR Origin xxx
Sen: PF Origin xxx
Sen: Cover xxx
Sen: Lever xxx
Sen: PaperEdgeAD xxx
Sen: PaperFrontAD xxx
Sen: PaperRearAD xxx
Sen: Paper Wide
Sen: HeadSlide xxx
Sen: Temp B 20° C
Sen: Temp C 20° C
Adjustment
Sen: Lever B Down
Sen: Lever C
XXX
Sen: B Ink ID
XXX
Sen: C Ink ID
XXX
Sen: M Ink ID
XXX
Sen: Lc Ink ID
XXX
Sen: Lm Ink ID
XXX
Sen: Y Ink ID
XXX
Sen: B Ink NOT
XXX
Sen: C Ink NOT
XXX
Sen: B Ink END
XXX
Sen: C Ink END
XXX
[Item]
Adjustment Steps
Table 5-11. "Sensor" Function Confirmation Items
Table 5-12.
Display Item
CR Home Position
Shows the state detected by the HP sensor.
PF Home Position
(Not used.)
Cover
Shows the front cover open / closed state.
Lever
Shows the paper release lever's state (Lock/Release).
Paper Edge AD / Paper
Shows the state detected by the paper sensors'
Front AD / Paper Rear
(P_EDGE, P_FRONT, P_REAR).
AD"
Paper Thickness
Shows the state detected by the paper thickness
detection sensor.
Head Slide
Shows the state detected by the PG cam home
position detection sensor.
Temperature B / C
Shows the temperature detected by the Thermistor
inside the B and C heads.
Ink Lever B / C
Shows the I/H holder lever position detection state.
Ink ID
Shows the detection state of the ID sensors inside the
I/C holder of each color, and displays it as the 0 ~ 7
value. If the sensor is ON, a 1 is displayed, and if it is
OFF, a 0 is displayed.
B / C Ink NOT
Shows the state detected by the I/C sensor, whether
the I/C is present or not, and displays the name of the
I/C that is not installed. (Example: When the Lm I/C is
not installed, "Lm" is displayed.)
B / C Ink END
Shows the state detected by the ink low detection
sensor and shows the name of the I/C where the ink
low state is detected.
When replacing the circuit board, or when replacing
the P_THICK, P_REAR or P_FRONT sensor, the
following adjustment should be made.
n
Sensor Adjustment (See the next page.)
Revision A
Contents
191