Epson Stylus Pro 9500 Service Manual page 172

EPSON Stylus Pro 9500
ADJ CHECK NOZZLE
After the initial ink charge, this function verifies that the nozzles are properly
firing ink If the some nozzles are not firing correctly or at all, you can run the
cleaning operation from this menu.
1. Make sure "Adj: Check Nozzle" appears on the LCD and press the Enter
button.
2. Load paper if not already loaded and replace any low or empty ink
cartridges if detected. If these conditions are OK, the printer prints the
following check pattern.
The pattern includes the following colors from left to right; black, cyan,
magenta, yellow, light magenta, and light cyan.
n
Also, after the above patterns, the following items are printed at the
same time.
n
Firmware version
n Waste ink counter remaining capacity (%)
n Vertical nozzle alignment check pattern
n Horizontal nozzle alignment check pattern
Adjustment
3. When the check pattern is finished printing, "Nozzle Check End" appears
on the LCD. If the pattern printed all six colors properly with no lines or dots
missing, press the Enter button to end this adjustment procedure. If lines or
dots are missing, press the SelecType button to start the cleaning cycle.
Replace any low or empty ink cartridges.
Adjustment Steps
Please Set Paper
Load paper.
Please Set Ink
Printing Pattern
[Enter]
Nozzle Check End
Cleaning Standard
Print Adj. Pattern
Revision A
[SelecType]
End
adjustment/
proceed to
next
172