Epson Stylus Pro 9500 Service Manual page 136

EPSON Stylus Pro 9500
AFFIXING LABELS
1. Affix the following labels in the specified locations.
n EPSON _COLOR FAST Label
Affix this label on the right front of the H top cover.
n Manual Cutter Cutting Position Labels
Horizontal Position: Align the scissors cutting line on the label with a
position 10 cm down from the bottom edge of the sub-
platen.
Vertical Position: Align the label along the same line as the sub-platen's
right edge.
n Right Ink Cartridge Model No. Label
Affix the right ink cartridge Model No. label over top the dye based
ink label.
n Left Ink Cartridge Model No. Label
Affix the left ink cartridge Model No. label over top the dye based ink
label.
For details, see the figure below.
EPSON COLOR FAST
Figure 4-97. Label Affixing Positions
Disassembly & Assembly
PIGMENT INK INITIAL FILLING
1. Take the 6 pigment ink cartridges from the conversion kit and set them in
the I/H holders. Lower the ink lever securely.
2. Insert the AC cable in the outlet.
3. When the printer's power switch is turned on, the initial filling sequence will
start automatically. Approximately 7 minutes is necessary to complete this
sequence. The main initial filling flag starts based on the flag set in the "Ink
Discharge Procedure" on page 124.
Sub-platen
10cm
Disassembly Flow
Revision A
136