Epson Stylus Pro 9500 Service Manual page 134

EPSON Stylus Pro 9500
29. Take out the 2 screws holding the CR cover, then remove the CR cover
Figure 4-92. Removing the CR Cover
30. Take out the one screw holding the damper holder on the CR unit, then
disconnect the 6 ink tubes form the damper holder. Slide the damper
holder to the right side and remove it.
Figure 4-93. Removing the Damper Holder
Disassembly & Assembly
31. Pull out the 6 dampers from the print heads carefully, wrapping each one in
CR cover
32. Loosen the hex nuts used to fasten the ink tubes to the dampers, then
33. Take off the ink tubes, and remove the O-rings from inside the hex nuts.
Disassembly Flow
a soft piece of cloth, etc. to prevent transport liquid from leaking out.
Figure 4-94. Removing the Dampers
remove them.
Revision A
134