Epson Stylus Pro 9500 Service Manual page 190

EPSON Stylus Pro 9500
VERSION
This function confirms the firmware version and dip switch settings.
[Pause] returns you
to previous menu
[SelecType]
Ver. Firm
Ver. Parameter Pnl XXXXX
Ver. Parameter Moe XXXXX
Ver. DipSW
Ver. Main Rev
Ver. Panel Rev
[Item]
NOTE: The Dip switch
The dip switch located on the Main Board is a 2-bit switch,
SW-1 is LSB (Least Significant Bit) and SW-2 is MSB (Most
Significant Bit). For example, if SW-1 = Off and SW-2 = On,
the LCD will display "Ver. DipSW 0x01".
Adjustment
XXXXXX
16 bit
hexadecimal
16 bit
hexadecimal
ON: 0
XXXXX
OFF: 1
XXXXX
XXXXX
CONTROL PANEL
This function allows you to check the operation of the control panel buttons,
LED indicators, and LCD panel.
[Pause] returns you
to previous menu
[SelecType]
Panel: Key
Panel: LCD
Panel: Key
[Item]
o
"Key" check
The name of the button that is pressed appears. Press the [Pause] button
twice to exit the "Panel: Key" function.
o
"LCD" check
All dots turn on. If a dot is not on, the LCD is not working properly.
o
"LED" check
The LED indicators turn on in the following order and the name of the
indicator appears in the LCD when it turns on.
Power, Pause, Ink End (K, C, Lc, M, Lm, and Y), Paper Out, Roll Auto Cut,
Roll Cut Off, and Sheet
Adjustment Steps
Revision A
[Enter]
Panel: Key XXXXXX
"XXXXXX" = name of pushed button
All dots = ON
Panel: LED XXXXXX
"XXXXXX" = name of flashing LED
[Pause] (press two times to exit "Panel: Key" function
190