Epson Stylus Pro 9500 Service Manual page 133

EPSON Stylus Pro 9500
26. Assemble the left waste ink pad box (1 screw), with the pads replaced with
new ones, in the printer.
When assembling the right waste ink pad box, first, set the
screws in the screw grooves in the waste ink pad box, then
carefully push the box into position. After that, tighten the
screws to fasten the box in place.
27. Take the left and right F boxes from the conversion kit and assemble them
in the printer (1 screw each).
Disassembly & Assembly
n Make sure the waste ink tubes of the pump assembly
are routed securely around the right side of the
maintenance assembly.
n Make sure the waste ink tube to the right F box is
fitted securely to the tube attachment position on the
maintenance assembly.
n Make sure the waste ink tube to the left F box is fitted
securely to the mechanism frame.
n Make sure the pump motor cable is run correctly.
Figure 4-91. Running the Pump Motor Cable
n Make sure the connector for the CR lock solenoid is
inserted in the CN9 connector on the relay board.
28. Assemble the paper guide L (9 screws) and right cover holder (1 screw) in
the printer.
Disassembly Flow
Revision A
133