Epson Stylus Pro 9500 Service Manual page 199

EPSON Stylus Pro 9500
"UPDATE" ITEMS
The items you can update are described below.
The parameters will update and be stored in the Flash
memory on the Main Board the next time the printer is
turned off.
o Capping Position (See page xx)
o
Head Rank (See page xx)
o
Print Position Items (Bi-D Adjustment/Gap Adjustment) (See page xx)
o Paper Feed Distance (See page xx)
o
Mechanical Parameters (See page 182.)
Update concerning the R and L flushing positions, and the top, bottom,
side and rear margins.
o Ink Parameters
By using this function, the initial filling flag can be set as desired. ("Set" =
Execution of the initial filling sequence the next time the power is turned
on.)
o
Dot Shift Mode
This mode sets an offset for the adjustment value in Bi-D adjustment
pattern No. 4. The initial setting is "Single Print."
If "Pair" is set based on the evaluation results, it will
be judged that there is shifting of the adjustment
results in the (Inter row corrections) in Bi-D No. 4, so
the setting should absolutely not be changed in
servicing.
If you change the setting, it will cause color
irregularity (vertical direction), so adequate caution
should be taken.
Adjustment
Update: Ink Parameter
Update Parameter?
Updating Parameter
Adjustment Steps
Paper Feed [+]/[-]
Init Ink Charge Flag:
Init Ink Charge Flag: RESET
Enter
Revision A
SET
199