Epson Stylus Pro 9500 Service Manual page 142

EPSON Stylus Pro 9500
5. If the measuring results are outside the standard, loosen about 2 of the
screws holding the paper guide L, then carry out fine adjustment of the
paper guide L's assembly position.
n The length from the edge of the cutter level
difference to the front edge of the paper where it was
actually cut should be within 0.5 mm _ 0.2 mm.
n If you are adjusting the assembly position of the
paper guide L, the installation screws that are
loosened should be the absolute minimum number
of screws necessary to adjust the position. If a large
number of screws is loosened, the assembly
position of the paper guide L will shift a great
distance from the original adjustment position, so
caution should be exercised.
6. In the same way, set paper on the left side of the printer, cut the paper
manually and measure the length from the cutter level difference to the
front edge of the paper. If the measurement results are not within the
standard, loosen about 2 of the screws holding the paper guide L and carry
out fine adjustment of the paper guide L's assembly position.
Disassembly & Assembly Disassembly Flow
Revision A
142