Epson Stylus Pro 9500 Service Manual page 130

EPSON Stylus Pro 9500
12. Wrap a piece of cotton or a rag around the front ends of the waste ink
tubes that are run from the pump to prevent ink from leaking.
Figure 4-81. Preventing the Leakage of Ink from the Waste Ink
13. Remove the waste ink pads from the conversion kit and replace the waste
ink pads in the left and right waste ink pad boxes with new ones.
n Right waste ink pad box: Replace a total of 27 pads.
n Left waste ink pad box: Replace a total of 7 pads.
After replacing the pads, place the left and right waste ink pad boxes off to
the side where they will not be in the way while the rest of the operation is
being completed.
After replacing the waste ink pads with new ones, place the
used pads in the plastic bag where the new pads were
packed, return it to the service center and dispose of it
properly.
Disassembly & Assembly
Tubes
14. Pull the CR lock cable out of the CN9 connector on the relay board on the
right side of the printer.
Figure 4-82. Removing the CN9 Connector Cable
15. Release the CR lock lever manually and move the CR unit from the
capping position.
Figure 4-83. Releasing the CR Lock Lever
Disassembly Flow
Release the Carriage Lock Lever
Revision A
130