Epson Stylus Pro 9500 Service Manual page 107

EPSON Stylus Pro 9500
4.2.3.8 MAINTENANCE ASSEMBLY REMOVAL&
DISASSEMBLY
If the "Service Call 00000100" error occurs, you need to
replace the Waste Ink Pads and Box R well as replace the
Pump Assembly, Cap Assembly, and Head Cleaner on reset
the Maintenance Assembly. In addition, you need to reset
the following counters.
n
INIT. WASTE INK (see page 38)
n
INIT. CREANER (see page 38)
You also need to perform the Cutter Position Adjustment.
If the Maintenance Assembly is removed, the following
adjustments should be made.
n
Paper guide L installation position adjustment. Refer to
page 204
n
Check the paper cutting position. Refer to page 207.
Depending on the condition, adjust the cutter
installation position and adjust the CR cover height.
1. Remove the paper guide L. (See 4.2.1.6.)
2. Remove the R side cover. (See 4.2.1.3.)
3. Remove the right- side Waste Ink Box.(See 4.2.3.1)
4. Remove the two (CP(W2)M4x6)screws securing the Maintenance
Assembly frame to the printer.
5. Take out the 4 screws (CP(W2) M4 x 8) holding the "Deceleration pulley
support" on the side of the left side frame.
6. Disconnect the two cables from the connectors CNN9 (to CRL Look
Solenoid) and CN19 (to Pump motor), and then remove the Maintenance
Assembly.
When removing the Maintenance Assembly, the ink tubes
connected to the Pump Assembly may leak or drip ink. It is
a good idea to wipe the ends of these ink tubes off before
removing the maintenance Assembly.
Disassembly & Assembly
Figure 4-39. Maintenance Assembly Removal - 1
Figure 4-40. Maintenance Assembly Removal - 2
Disassembly Flow
Revision A
.
107