Jumper Settings - Epson Stylus Pro 9500 Service Manual

EPSON Stylus Pro 9500

1.3.7 Jumper Settings

The factory default settings for jumper and DIP switch on the Main Board
(C277MAIN) are as follows.
Table 1-33. Jumper Settings
Type
Jumper
Jumper
DIP-SW SWD1 "1" (1-4)
DIP-SW SWD1 "2" (2-3)
n
The above jumper settings are used for factory settings
only, and should not be changed during servicing. These
jumper settings determine the matching of the firmware,
CPU and ASIC, etc., so if they are inadvertently changed, it
will become impossible to operate the printer.
n
When installing the ASP board, the DIP-switch settings
should be changed as shown below. For details
concerning settings, see page 100.
•DIP-Switch Setting
•ASP Board
•When board installed OFF
Table 1-34. Printer Status Menu
Display message
VERSION Shows the firmware version.
INK LEFT-K Shows the amount of remaining ink - Cyan
INK LEFT-M Shows the amount of remaining ink - Magenta
INK LEFT-LC Shows the amount of remaining ink - Light Cyan
INK LEFT-LM Shows the amount of remaining ink - Light Magenta
INK LEFT-Y Shows the amount of remaining ink - Yellow
INK LEFT-K Shows the amount of remaining ink - Black
Product Description
Number Setting
JP1 Shorted
JP2 Shorted
OFF (Open)
OFF (Open)
DIP-SW1 DIP-SW2
OFF OFF
ON
Meaning
Table 1-34. Printer Status Menu (continued)
Display message
CUTTER LIFE
TOTAL PRINTS
WASTE INK
CR MOTOR
PF MOTOR
HEAD UNIT
CLEANER
See the following table concerning the display format for each item.
Control Panel
Meaning
Shows the remaining useful life of the cutter
Shows the total number of printed documents
Displays the CR motor life.
Displays the PF motor life.
Displays the head unit life.
Displays the head unit life.
Displays the maintenance kit life.
Revision A
42