General Maintenance Issues - Epson Stylus Pro 9500 Service Manual

EPSON Stylus Pro 9500

6.1 General Maintenance Issues

This section explains necessary maintenance items and their details for this
product. Basically for this product, service technicians are required to visit the
user's location where the EPSON Stylus Pro 9500 is used, and perform
necessary maintenance service on-site while following the precautions below.
Service technicians have to be extra careful not to cause any accident to the
product or the user's environment.
n Since the power switch mounted on the secondary
circuit of the power supply circuit, unless otherwise
specified, always disconnect the power cable from
the AC plug socket in order to prevent electric shock
during service operations.
n The cover open sensor for detecting the open/close
condition of the front cover has an interlock switch
that functions as a safety device. Therefore, it is
prohibited to turn off this switch.
n A lithium battery is used to back up memory and is
mounted on the control circuit board. To prevent
accidents, follow the precautions below when
handling the board.
*Do not short the battery.
*Do not set the battery on the wrong poles, double
check the plus and minus sides when installing the
battery.
*Do not heat up or place the battery neat a heat
source.
n Be careful not to let ink get into your eyes or your
skin. If ink gets in your eye, flush the eye with water,
and see a doctor if you feel discomfort in your eye.
Maintenance & Setup
n Due to the printer's size, when performing any
n Due to the printer's size and weight, make sure the
n Since the EPSON Stylus Pro 9500 is very heavy
n When removing parts, ink may drip on the floor or
n When handling the electric circuit boards, do not
n If it is necessary to power on the printer after
n Since the steel belt for driving the carriage and cutter
n Since the cutter blade is made of very hard material
n If the installed printer needs to be packed and
General Maintenance Issues
.
service or maintenance operations, confirm there is
plenty of space for the operation.
area you move and place the printer is stable.
(approximately 96 Kg for the printer body + stand),
be careful when handling it. When separating or
assembling the printer body and legs, it is
recommended to do so with at least 4 people.
lower sections of the printer. Therefore, spread a
sheet or similar object when removing ink-related
parts.
touch the elements on the board by the bare hands in
order to prevent the elements from getting damage
by static electricity. If necessary, wear the earth
band.
removing various covers by necessity, be careful not
to get injured from the carriage or fan.
blade are very sharp, be careful not to cut yourself.
but weak against shocks, do not let it collide with the
printer's metal parts.
transported for any reasons, use the all the exclusive
packing materials and protection materials written
on the "Start-Up Guide" and "Assembly and Setup
Guide".
Revision A
220