Epson Stylus Pro 9500 Service Manual page 162

EPSON Stylus Pro 9500
5.2.1.1 Operating Procedure
Backup to a PC card and transfer of parameter data from a PC card to NVRAM
on the main board is accomplished by the following procedure.
BACKUP OF PARAMETERS TO A PC CARD
o
Backing up (uploading) data to the PC card
1. Remove the access cover the top of the Upper Paper Guide, if necessary.
Also, make sure the Control Panel unit is attached.
2. Insert the PC card into the PC card slot connector on the Main Board, and
then turn on the printer.
3. Make sure the following message appears on the LCD, and wait for the
procedure to begin.
Wait:F->M Push:M->F
4. The backup procedure starts about 15 seconds after the message
appears.
Flash -> Mcard
Do not touch the Control Panel buttons during this
procedure. Doing so causes the PC card to download
its data to the Main Board's Flash memory instead of
backing up the data in Flash memory. This overwrites
the Flash memory so be careful.
5. When the backup procedure is finished, the following message appears.
End [Success]
6. After making sure the printer is finished, turn off the printer and remove the
PC card.
Adjustment
o Downloading the data from the PC card to the printer
1. Make sure the access cover is removed from the top of the Upper Paper
Guide, add make sure the Control Panel is attached.
2. Insert the PC card containing the backup data into the PC card slot
connector on the Main Board, and turn on the printer.
3. Make sure the following message appears on the LCD.
4. Press any button on the Control Panel to start the download procedure.
If you wait 15 seconds before you press one of the
Control Panel buttons, the printer will start the backup
procedure instead of the download procedure. This
overwrites data stored in the PC card with data stored
in the Main Board Flash memory.
5. When the download procedure is finished, the following message appears.
6. After making sure the printer is finished, turn off the printer and remove the
PC card.
Adjustment Steps
Wait:F->M Push:M->F
Mcard -> Flash
End [Success]
Revision A
162