Epson Stylus Pro 9500 Service Manual page 102

EPSON Stylus Pro 9500
4.2.3.5 Removing the PF Motor X Deceleration Belt
When removing the X deceleration belt, be careful not to get
injured by the scale for the PF encoder sensor.
1. Remove the L side cover. (See 4.2.1.3.)
2. Remove paper guide L. (See 4.2.1.6.)
3. Take out the 4 screws (CP(W2) M4 x 8) holding the "Deceleration pulley
support" on the side of the left side frame.
Deceleration pulley support
Figure 4-28. Taking Out the Deceleration Pulley Support
Installation Screws
Disassembly & Assembly
Deceleration pulley support
installation screws.
Disassembly Flow
4. Take out the 2 screws holding the PF encoder sensor mounting plate.
PF Encoder Sensor
Mounting Plate
Figure 4-29. Removing the PF Encoder Sensor Mounting Plate
5. Loosen the 4 screws (CP(W2) M4 x 12: blue screws in the figure) holding
the "X Motor Mounting Plate", then release the tension on the X
deceleration belt.
6. Take out the 2 screws (CP(W2) M3 x 8: red screws in the figure) holding
the PF motor pulley assembly on the "X Motor Mounting Plate," then
remove the PF motor pulley assembly.
Figure 4-30. Removing the PF Motor Pulley Assembly
Revision A
102