Epson Stylus Pro 9500 Service Manual page 217

EPSON Stylus Pro 9500
NOTE: In any case, the following operation is only a check
operation, so if the cover R/L sensor assembly is replaced or
the front cover is installed, the adjustment shown on the
previous page should be carried out when assembly is done.
The following operation is effective only when the H-Top
cover and R/L side cover are assembled.
1. Press the following buttons and turn on the printer to enter the Self-
Diagnostics mode.
Paper Feed + Cut/Eject + Cleaning
2. Press the SelecType or Item button until "Check: Test" appears in the LCD,
then press the Enter button to select the Test menu.
3. Press the SelecType or Item button until "Test: Sensor" appears in the
LCD, then press the Enter button to select the Test Item menu.
4. Press the SelecType or Item button until "Sen: Cover xxxx" appears.
5. Open and close the Front Cover, checking the LCD to make sure the
message changes depending on the Front Cover position.
Table 5-21. Cover R/L Sensor Assembly Check
Front Cover
Open
Closed
6. If the correct message does not appear or any other message appears,
verify the Cover R/L Sensors are installed correctly and check the
operation again.
Adjustment
LCD Message
Sen: Cover Open
Sen: Cover Close
Adjustment Steps
Revision A
217