Epson Stylus Pro 9500 Service Manual page 119

EPSON Stylus Pro 9500
7. Turn the I/C holder that is being removed on its back, then loosen the hex
nuts to the ink pipes installed in "Holder assembly, valve, A" and remove
the ink pipes.
8. Disconnect the cable corresponding to the I/C holder that is being removed
from the I/H relay board on the bottom of the cartridge holder assembly.
Lock Nut
Figure 4-64. Removing the ink pipe
Disassembly & Assembly
HOLDER ASSY., VALVE,A
Disassembly Flow
Table 4-4. Connection between each I/C holder and relay board
I/C Holder I/C ID sensor
Black
(Light Cyan)
Cyan
(Light Magenta)
Magenta
(Yellow)
CN7 CN5
CN4
CN6
CN8
Figure 4-65. Connector location on the I/H relay board
Revision A
I/C In sensor
Ink low sensor
CN3 CN4
CN5 CN6
CN7 CN8
Magenta / Yellow Holder
Cyan / LM Holder
Black / LC Holder
CN3
CN1
FFC
CN2
I/H position sensor
119