Epson Stylus Pro 9500 Service Manual page 208

EPSON Stylus Pro 9500
After performing this adjustment, be sure to perform
n
the following adjustment.
• CR Cover Height Adjustment
CR COVER HEIGHT ADJUSTMENT
This adjustment is applicable in the case of all operations which are
accompanied by removal and installation of the CR cover.
The CR cover restricts the cutter solenoid's actuator operating position, and
this adjustment sets the CR cover so that the cutter operates at the proper
stroke when it is being used to cut paper.
1. Set the "CR Cover Position Adjustment tool No. #F724, on the sub-platen
in the position shown in the following figure along the sub-platen on paper
guide L.
2. Move the carriage over the tool while matching it to the level difference in
the tool, and check if the cutter blade enters the groove.
The cutter blade is made from an ultra-hard material
and should not be bumped against any metal parts.
(Bumping it could cause it to become nicked.)
For this reason, if you are moving the cutter blade in
the tool, move it while pushing the cutter front end up
with your finger.
3. Fasten the CR cover with it pushed down so the cutter pushes against the
tool. (Since the position will change only as much as the amount of
looseness in the installation screw holes, position it so that it will hit against
the tool.)
Standard: 9.75 +/- 0.25 mm (Using tool: #F724)
Adjustment
Figure 5-18. Checking the tool Setting Position
Adjustment Steps
Revision A
Set the tool
here.
208