Epson Stylus Pro 9500 Service Manual page 78

EPSON Stylus Pro 9500
o
Solution
n
A)~C) above
Properly reload paper. If the front edge of the paper is not straight and
clean, cut the paper.(If the paper is pulled back and set 60 mm or more
from the criterion line (hole), it will exceed the permissible amount of
backfeed (200 mm from the paper edge detection sensor position and
result in an error.)
n
D)~E) above
Cut of the section of the paper that has ejected/protruded and reload
the rest of the paper. For paper that is automatically cut, lift up the
Release Lever (the "Load Paper" message appears), fix the position of
the paper, and lower the Release Lever. If you select you "Roll Paper/
Auto Cut" setting, you can cut off the protruding part of the paper using
the Cut button.
n
If the error recurs even after reloading the paper, make sure the paper-
end sensor on top of the carriage is installed correctly and working
properly.
PUSH LEVER DOWN
o
Problem
The printer is not able to continue paper feeding/initializing, printing, or ink
sequencing because the Release lever was moved to the Release
position. Or, the printer cannot begin printing because the lever is in the
release position.
o
Solution
n
Push down the lever. However, if printing was interrupted because the
lever was pushed to the release position and the paper shifted, the
print job may be marred.
n
If the lever is down and this error still occurs, check the Release-Lever
position sensor.
COMPARTMENT OPEN
o
Problem
An Ink Holder (I/H) compartment door is open.
o
Solution
Troubleshooting
n
Push the I/H lever down to the lock position.
n
If the lever is down and this error still occurs, check the lever position
sensor.
INK OUT
o
Problem
One or more ink cartridges have run out of ink, a near-end cartridge has
been reinstalled, or an unsupported ink cartridge has been installed.
o
Solution
n
Replace the empty ink cartridge.
When replacing an empty ink cartridge, always replace
it with a new ink cartridge; otherwise the printer
cannot determine how much ink remains.
n
Make sure the ink cartridge is the proper type of cartridge for the
printer and the proper color for that slot.
n
If the proper cartridge is installed and this error still occurs, check the
Ink-End sensor and the Ink ID sensor.
NO INK CARTRIDGE
o
Problem
An ink cartridge is not installed or is not installed properly.
o
Solution
n
Install the proper ink cartridge in the empty slot.
When replacing an empty ink cartridge, always replace
it with a new ink cartridge; otherwise the printer
cannot determine how much ink remains.
n
If the proper cartridge is installed and this error still occurs, check the
Ink-Cartridge sensor.
Outline
Revision A
78