EPSON Stylus Pro 9500
4.2.3.10 Ink System Mechanism Disassembly
This section describes the Ink System Mechanism components and the
procedure for disassembly.
Removing and re-installing the ink system mechanism
components requires ink discharge and initial charge
operation. Refer to page 167 of the Chapter-5 Adjustment
for the detail procedures.
REMOVING THE I/C HOLDER ASSEMBLY
1. Perform ink discharge operation to eject inks from all ink paths.
2. Remove the side covers (L/R) (See 4.2.1.3)
3. Remove the four screws (CP(W2) M3x6) securing the ink tube fixing plate,
and loosen the lock nut securing the ink tubes to the ink pipes ad
disconnect the ink tubes from the ink pipes.
4. Remove the four screws (CP(W2) M2x4) securing the access cover
attached at the back of the I/H assembly.
Disassembly & Assembly
Figure 4-52. Disconnecting the ink tubes
Figure 4-53. Removing the access cover
Disassembly Flow
Revision A
Ink tube fixing plate
114