Epson Stylus Pro 9500 Service Manual page 195

EPSON Stylus Pro 9500
2. Raise the paper set lever, then set a sheet of #F751 Kimoto Micro Tracing
Paper (A3 size) A3 in the paper path, then lower the paper set lever to fix
the paper in position. At this time, make sure the front edge of the sheet of
paper is at the paper front edge setting position on paper guide L.
3. Close the front cover halfway. At this time, if the vvv value in the LCD
display does not change, the subsequent operation can be performed with
the front cover in the open state. If the vvv value changes, use adhesive
tape, etc. to fix the front cover in the half closed state.
4. Confirm that the LCD displays the following.
n
LCD Display: "Sen: Rear AD ttt vvv"
n ttt value: 40<H> or higher
n
vvv value: 95<H> or lower
If the above conditions are not met, adjust the VR3 element while checking
the display in the LCD and adjusting the values so they match the above
conditions.
5. Raise the paper set lever, then after removing the paper, return the paper
set lever to the paper set position.
6. Turn the printer's power switch off, then close the access cover and tighten
the installation screws.
Adjustment Adjustment Steps
Revision A
195