Epson Stylus Pro 9500 Service Manual page 89

EPSON Stylus Pro 9500
FRONT COVER ASSEMBLY REMOVAL
1. Remove the Maintenance Cover.(See 4.2.1.1)
2. Remove the H Top Cover.(See 4.2.1.2)
3. Remove the L/R Side Covers as described in the previous section.
4. Remove the three screws (CP(W2) M3x8) securing the damper assembly
on the left side, and then remove the damper assembly.
5. As shown below, the Front Cover Assembly is supported by a shaft and
brackets on both sides. The shaft is secured to these brackets with three
screws (CP (W2) M3x8), two on the right and one on the left.
Left side
Right side
Figure 4-8. Locations of Front Cover shaft screws
Disassembly & Assembly
CP(W2) M3x8 screws
Disassembly Flow
The roll assembly parts and guide on the left side of the
Front Cover shaft are not fixed and will slide off the shaft if
the shaft is tilted down to the left.
Figure 4-9. Front Cover Removal
Revision A
89