Epson Stylus Pro 9500 Service Manual page 228

EPSON Stylus Pro 9500
ASSEMBLING THE PRINTER BODY
n When lifting or moving the printer body, make sure
to do so with at least 4 people. (The printer weighs
approximately 74kg.)
n When removing the large box, be sure that there is
enough space overhead. (2 meters of clearance is
required.)
1. Open the large box by cutting the center of the sealed tape and take out
the Accessory Box, two spindles and two styrol pads protecting the printer
body on the right and left.
2. Take out the four box panels, one on each side of the box and remove the
Documentation box.
Figure 6-8. Body Assembly 1
Maintenance & Setup Unpacking and Installing
Figure 6-9. Body Assembly
Revision A
228