Epson Stylus Pro 9500 Service Manual page 111

EPSON Stylus Pro 9500
REMOVING THE P_FRONT SENSOR
1. Remove the lower paper guide.(See 4.2.1.6)
2. Disconnect the cable from the connector CN11 on the relay board.
3. Remove the one screws (CP(W) M3x6) securing the sensor assembly, and
remove the P_FRONT sensor together with the mount plate.Position the
screw in the back of the mounting plate.
One screw
(behind the sensor board)
Figure 4-47. P_FRONT sensor removal
When removing the P-FRONT sensor, the following
adjustment should be made since the paper guide L will be
removed.
n Paper guide L installation position adjustment. Refer to
page 204.
n Check the paper cutting position. Refer to page 207.
Disassembly & Assembly
REMOVING THE LEVER POSITION SENSOR / HD_SLID HP
SENSOR
1. Remove the side cover R.(See 4.2.1.3)
2. Disconnect the cable from the connectors on the relay board.
CN17 = to HD_SLID HP sensor
CN10 = to LEVER POSITION sensor
3. Remove the two screws (CP(W) M3x6) securing each sensor assembly,
and remove the LEVER POSITION / HD_SLID HP sensor together with the
mount plate.
Figure 4-48. LEVER POSITION / HD_SLID HP sensor removal
When removing the head SLIDE HP sensor, the following
item should be checked.
n SLIDE motor assembly backlash adjustment. Refer to
page 214.
Disassembly Flow
HD_SLID HP sensor
LEVER POSITION sensor
Revision A
111