Epson Stylus Pro 9500 Service Manual page 25

EPSON Stylus Pro 9500
OPERATION BUTTONS
The functions of each of the buttons on the operation panel are as shown in the
following table.
Table 1-17. Control Panel Buttons & Functions
Button Function
(Second function) (Normal)
Power Power on/off
• Switch - online/off-line
Pause
• Reset (press for three
(Reset)
seconds
Enters SelecType mode
(when printer is in Standby
SelecType
mode)
Selects *1
Cut/Eject • Auto Cut
• Cutter Off
(Enter)
• Sheet
Paper Feed Feeds paper backward *2
Paper Feed
Feeds paper forward *3
(-)
Paper Source
Selects paper source
(Item)
Cleans both heads if
Cleaning
pressed for three seconds
Paper Source
Cut/Eject
Paper Feed
Paper Source
Cut/Eject
Cleaning
Paper Feed
Cut / Eject
Cleaning
Product Description
SelecType Power-On
Function Function
N/A N/A
Maintenance
N/A
mode
Selects menu or major
category
Confirm and save value
Cycles backward/
N/A
increases value
Cycles forward/
decrease value
Selects item or minor
category
N/A
Maintenance
N/A
Mode 2
Firmware
N/A
Update Mode
Self-
N/A diagnostic
Mode
Control Panel
Notes:
1: During the ink drying time, ink drying is interrupted and the specified operation is
performed.
2: For 2 seconds after the button is pressed, the paper is fed at 12.7 mm/sec. (5.0 cps). If
the button is pressed for 2 seconds longer, the paper is fed at 76.2 mm/sec. (50.0 cps).
However, the paper can be reversed up to a maximum of 200 mm when the button is
pressed once.
3: For 2 seconds after the button is pressed, the paper is fed at 12.7 mm/sec. (5.0 cps). If
the button is pressed for 2 seconds longer, the paper is fed at 76.2 mm/sec. (50.0 cps).
LED INDICATORS
Table 1-18. LED Indicators
LED Status
• On • Power on
Operate
• Flashing • Fatal error during data processing or during
(Green)
• On • Shows the no paper, roll paper end, roll paper/
• Flashing
Paper Out
(Red) • Shows a paper jam, paper cutting error, paper
• On • Print ready state.
Pause
• Flashing • Blinks during head cleaning, during ink drying
(Green)
• On • Ink end error state (K), I/C wrong insertion.
Ink Out K
• Flashing • Ink low state (K)
(Red)
• On • Ink end error state (C), I/C wrong insertion.
Ink Out C
• Flashing • Ink low state (C)
(Red)
• On • Ink end error state (M), I/C wrong insertion.
Ink Out M
• Flashing • Ink low state (M)
(Red)
• On • Ink end error state (Y), I/C wrong insertion.
Ink Out Y
• Flashing • Ink low state (Y)
(Red)
• On • Ink end error state (LC), I/C wrong insertion.
Ink Out LC
• Flashing • Ink low state (LC)
(Red)
Revision A
Condition
power off processing.
cut sheet paper setting difference, paper support
lever released or cleaning impossible error state.
skew error, paper recognition error, cut sheet
paper eject failure, or fatal error state.
time, and during initial filling processing.
25