Epson Stylus Pro 9500 Service Manual page 106

EPSON Stylus Pro 9500
4.2.3.7 Removing the PF Motor Pulley Assembly
1. Remove the L side cover. (See 4.2.1.3.)
2. Remove the paper guide L. (See 4.2.1.6.)
3. Loosen the 4 screws (CP(W2) M4 x 12: blue screws in the figure below)
holding the X motor mounting plate and release the tension on the X
deceleration belt.
At the place where the tension is released, workability will
be improved if the X motor mounting plate is tightened
temporarily.
4. Take out the 2 screws (CP(W2) M3 x 8) holding the PF motor pulley
assembly to the X motor mounting plate and remove the PF motor pulley
assembly.
Figure 4-38. Removing the PF Motor Pulley Assembly
5. Push the PF motor inside the printer and remove the PF motor pulley.
Disassembly & Assembly
If the PF motor pulley is removed, the following
adjustments should be made.
n Paper guide L installation position adjustment
Refer to page 204.
n Check the paper cutting position. Depending on the
condition, adjust the cutter installation position and
adjust the CR cover height. Refer to page 207.
n X belt tension adjustment. Refer to page 213.
Disassembly Flow
Revision A
I
106