Epson Stylus Pro 9500 Service Manual page 132

EPSON Stylus Pro 9500
18. Take out the one screw holding the cap assembly on the maintenance
assembly that has just been pulled out, then disconnect the 2 waste ink
tubes from the cap assembly and remove the cap assembly.
19. Take out the 2 screws holding the side frame on the maintenance
assembly, then remove the side frame and reduction gear.
Pull the waste ink tubes out of
the cap assembly.
Fasten the cap assembly to
the maintenance assembly.
Maintenance assembly side frame
installation screws, 2 pcs.
Figure 4-88. Removing the Cap Assembly
20. Take out the one screw holding the pump assembly, then remove the
pump assembly from the maintenance assembly.
Pump Assembly
Pump Assembly
Installation Screw 1 pc.
Figure 4-89. Removing the Pump Assembly
Disassembly & Assembly
21. Take the pump assembly out of the conversion kit and assemble the head
cleaner with tweezers.
n Adequate caution should be used when handling the
head cleaner. Bare hands should not be used.
n When assembling the head cleaner, it should be
assembled so that the felt part of the head cleaner is
on the pump's right side and the rubber part is on the
pump's left side, as shown in the figure below.
NOTE: When assembling the head cleaner, it should be assembled so
that the felt part of the head cleaner is on the pump's right side and
the rubber part is on the pump's left side, as shown in the figure
below.
Pump Assembly
Figure 4-90. Fig. 4-90 Assembling the Head Cleaner
22. Assemble the new pump assembly (1 screw) and side frame (2 screws),
the cap assembly (1 screw) and maintenance assembly following the
procedure in steps 18, 19 and 20 in reverse order.
23. Assemble the maintenance assembly in the printer. (3 screws)
24. Insert CN9 in the relay board's connector.
25. Assemble the right waste ink pad box (2 screws), with the pads replaced
with new ones, in the printer.
Disassembly Flow
Revision A
Felt Side
Rubber Side
132