Dip Sw Setting - Epson Stylus Pro 9500 Service Manual

EPSON Stylus Pro 9500

5.2.10 Dip SW setting

The ASP on the C277MAIN board is common with that i the Stylus Pro 9000,
but due to the mechanical configuration, the DIP-Switch settings on the MAIN
board differ as shown below.
Table 5-22. C277MAIN Board DIP-SW Settings
DIP SW1 DIP SW2 Affected Product
1 OFF ON Stylus Pro 9000
2 ON OFF No affected product
3 OFF ON Stylus Pro 9500
4 ON ON No affected product Spare Setting
The DIP switch factory setting for the ASP C277MAIN board is setting No. 1
above, so if it is used in the Stylus Pro 9500, the setting should be changed to
No. 3 in the table above. The location of the DIP Switch is as shown in the
following figure.
Figure 5-30. C277MAIN DIP Switch Settings
NOTE: Jumpers J1 and J2 should be used with the short setting as is. If
the setting is changed, the printer will cease to operate.
Adjustment
Mechanical Configuration
• PF Roller: 3 roller configuration
• PF Motor: Built-in encoder
• PF Roller: 1 roller configuration
• PF Motor: Built-in encoder
• PF Roller: 1 roller configuration
• PF Motor: Encoder is mounted
externally.
ON
SW1 SW2
Adjustment Steps
Revision A
218