Epson Stylus Pro 9500 Service Manual page 118

EPSON Stylus Pro 9500
3. Set the I/H assembly frame down, then lift the cartridge holder assembly
straight up and remove it.
4. Take out the 2 screws (CP(W2) M3 x 4), then remove the I/C cover. Next
take out the 5 screws (2 screws = CP(W2) M3 x 4, 3 screws = P tight M3 x
4), then remove the I/C holder fastening plate.
5. The I/C holders are each independent of the other, so they can be
removed individually. If you are removing one I/C holder, first, take out the
1 screw (CP(W2) M3 x 4) holding the I/C holder to the base frame.
6. Overturn the entire cartridge holder assembly, then take out the screw
(CP(W2) M3 x 4) holding the I/C holder from the bottom surface of the base
frame.
I/C Cover
Figure 4-61. Removing the I/C cover and the fixing plate
Disassembly & Assembly
Figure 4-62. Removing the screw (from the top)
Figure 4-63. Removing the screw (from the bottom)
Disassembly Flow
Revision A
118