Setting The Dip Switches; Setting Procedure - Epson OmniLink TM-T70-i Technical Reference Manual

Setting the DIP Switches

Follow the steps below to change the DIP switch settings.

Setting Procedure

Follow the steps below to change the DIP switch settings.
Before you remove the DIP switch cover, turn the product off.
Otherwise, a short-circuit may cause the product to malfunction.
CAUTION
DIP switch settings are enabled only when the power is turned on or the product is reset via
the interface. If the settings are changed after that, the functions will not change.
1
Make sure the power supply for the product is turned off.
2
Unscrew the screw to remove the DIP switch cover from the base of the
product.
3
Set the DIP switches, using a thin instrument such as a pair of tweezers.
4
Replace the DIP switch cover, and screw it in place.
DIP switch bank 2
DIP switch bank 1
Chapter 2 Setup
2
33