Bay 5 - Compaq AP400 Maintenance And Service Manual

Professional workstation
Hide thumbs Also See for AP400:
Table of Contents

Advertisement

Bay 5

Bay 5 is an internal bay (bracket) that supports third-height (1.0") or half-height (1.6") hard
drives. Bay 5 is located inside the chassis to the right of the drive cage. Installation and removal
procedures are unique for this bay.
NOTE: Compaq does not support mixing IDE and SCSI hard drives.
To install a hard drive in bay 5:
1.
Perform the service preparations described on page 3-2.
2.
Remove the workstation cover.
3.
Remove the screw securing the hard drive bracket to the chassis .
4.
Slide the bracket toward the rear of the workstation, then remove the bracket .
1
Figure 3-30. Removing the hard drive bracket (Bay 5)
5.
Place the hard drive in the bracket.
2
Compaq Professional Workstation AP400 Maintenance and Service Guide
3-29

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AP400 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Professional workstation ap400

Table of Contents