Bay 4 - Compaq AP400 Maintenance And Service Manual

Bay 4

Bay 4 supports both 3.5-inch and 5.25-inch devices. For a 3.5-inch device, a special mounting
bracket is required.
NOTE: Compaq does not support mixing IDE and SCSI hard drives.
Installing a 3.5-inch device
NOTE: This procedure describes the installation of a 3.5-inch hard drive. The same procedure
can be used for installing any 3.5-inch device in bay 4.
NOTE: If you are installing or removing a 10K RPM hard drive, see "Removing and Replacing a
10K RPM Hard Drive in Bay 4" later in this section.
To install an optional 3.5-inch drive in bay 4:
1. Perform the service preparations described on page 3-2.
2. Remove the following components:
workstation cover
front bezel
EMI shield (if installed)
Insert the drive into the mounting bracket 1.
3.
Insert the screws into the holes on each side of the bracket to secure the drive 2.
4.
2
Figure 3-24. Installing the 3.5-Inch hard drive in the mounting bracket
CAUTION: Use only 3/16-inch or 5-mm screws as retaining screws. Longer
screws can damage the internal components of the drive.
1
2
Compaq Professional Workstation AP400 Maintenance and Service Guide
3-23