Figure 4-19. Connecting the drive cables to the system board: 1 IDE diskette drive
5.
Remove the bezel blank from the subpanel inside the front bezel. See
the section "Removing the Bezel Blank."
6.
Replace the workstation access panel.
7.
Plug the network cable back into the system. Plug the power cord back
into the grounded AC outlet. Reconnect external devices.
8.
Reconfigure the workstation, if necessary. See the "When to
Reconfigure the Workstation" section in this chapter.
Installing a 3.5-Inch Drive into the
Third-height, 5.25-Inch Drive Bay
1.
Turn off the workstation and any external drives. Disconnect the power
cord from the grounded AC outlet. Disconnect the network cable and
any external devices from the system. Then remove the workstation
access panel.
IMPORTANT: On a power-managed system, the power cord MUST be
disconnected from the grounded AC outlet.
2.
Remove the front bezel.
3.
Install one guide screw on the right side of the drive.
connector, 2 IDE Ultra ATA hard drive connector 3 IDE CD-ROM connector
1
2
3
Compaq Professional Workstation AP200 Reference Guide
4-27