Processor Power Module
The processor power module is located on the system board with tray. To remove the processor
power module:
1.
Perform the service preparations desribed on page 3-2.
2.
Remove the following components:
workstation cover
I/O bracket assembly (expansion board bracket)
NOTE: For better access to the processor power module, you may need to slide the system
board with tray out half way.
3.
Press outward on both latches of the processor power module at the same time , then lift
it from the system board with tray .
Figure 3-44. Removing the processor power module
To replace the processor power module and reassemble the workstation, reverse the above steps.
IMPORTANT: Before replacing the I/O bracket assembly, read "Important Guidelines for
I/O Bracket Assembly Replacement" earlier in this chapter.
CAUTION:
Electrostatic discharge can damage electronic components. Be sure
you are properly grounded before beginning any installation procedure. See
"Electrostatic Discharge Information" in Chapter 2 for more information.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the
internal system components to cool before touching.
1
2
Compaq Professional Workstation AP400 Maintenance and Service Guide
3-45
Need help?
Do you have a question about the AP400 and is the answer not in the manual?