Installing A 3.5-Inch Drive Into A 5.25-Inch Drive Bay - Compaq Evo Workstation w4000 - Convertible Minitower Hardware Reference Manual

Hardware Upgrades

Installing a 3.5-Inch Drive into a 5.25-Inch Drive Bay

2–16
5. Connect the drive power 1 and signal 2 cables and, if it is a
CD-ROM or DVD-ROM drive and if analog audio is preferred to
digital audio, connect the audio cable 3 . The other end of the
audio cable 3 should be connected to the embedded audio
connector on the system board.
Connecting the Drive Cables
6. Remove the appropriate bezel blank from the subpanel inside the
front bezel. See the section "Removing Bezel Blanks" for more
information.
7. Replace the computer access panel.
8. Reconfigure the computer, if necessary. See the section
"Installation Sequence" for more information.
1. If you have locked the Smart Cover Lock, use Computer Setup to
unlock the lock.
2. Shut down the operating system properly, then turn off the
computer and any external drives, disconnect the power cord
from the power outlet, and remove the computer access panel.
3. Remove the front bezel.
4. Install one guide screw on the right side of the drive.
Hardware Reference Guide