5.25-Inch Drives - Compaq AP400 Maintenance And Service Manual

3-18 Removal and Replacement Procedures

5.25-inch Drives

To remove a 5.25-inch drive:
1. Perform the service preparations described on page 3-2.
2. Remove the following components:
workstation cover
front bezel
hard drive from bay 5 (if installed)
NOTE: If there is a hard drive in bay 5, you must remove it to access the mounting holes for the
retaining screws securing the drive assembly. For information on removing a hard drive from
bay 5, see "Bay 5" later in this chapter.
3. Disconnect all cables from the rear of the 5.25-inch drive.
Figure 3-18. Disconnecting the cables from the 5.25-inch drive
4. Remove the two screws securing the right side of the 5.25-inch drive.