Installing A Hard Drive In Bay 5 Or 6 - Compaq AP500 - Professional - 128 MB RAM Reference Manual

8-6 Drives

Installing a Hard Drive in Bay 5 or 6

Drive bays 5 and 6 can be configured with either 1.0-inch or 1.6-inch hard
drives. Other than using different screw holes, the installation for both drives
is basically the same. To install a 1.6-inch hard drive:
NOTE: Before installing a SCSI device, please read "SCSI Cables and
Guidelines" later in this chapter.
1. Turn off the workstation and disconnect the power cord from the
grounded AC outlet and the back of the workstation.
2. Remove the following components:
3. Refer to the following illustrations to install a 1.6-inch hard drive in
bay 5 or 6.
Figure 8-5. Installing a 1.6-inch hard drive in the hard drive bracket
side access panel
front bezel
cooling shield