Base Pan Assembly
The base pan assembly is the chassis or the frame that is left after removing all components. To
remove the base pan assembly:
1.
Perform the service preparations described on page 3-2.
2.
Remove components in the following sequence:
workstation cover
front bezel
I/O bracket assembly (expansion bracket assembly)
hard drive bracket
5.25-inch drive (if installed)
drive cage
system board assembly
power supply assembly
base pan cover
To replace or install a new base pan assembly, reverse the above steps.
Compaq Professional Workstation AP400 Maintenance and Service Guide
3-53
Need help?
Do you have a question about the AP400 and is the answer not in the manual?