Installing An Optical Drive Into The 5.25-Inch Drive Bay - Compaq dx1000 - Microtower PC Hardware Reference Manual

Installing an Optical Drive into the 5.25-inch Drive Bay

To install an optional 5.25-inch optical drive:
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as diskettes or compact discs, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
long as the system is plugged into an active AC outlet. You must disconnect the power cord to
avoid damage to the internal components of the computer.
5. Remove the access panel and front bezel.
6. If you are installing a drive in a bay covered by a bezel blank, remove the front bezel then remove
the bezel blank. See
7. If you are adding a drive to an empty lower optical drive bay, you must remove the knockout plate
from the bay. To do so, insert a flat screwdriver into the knockout plate slot and rotate the
screwdriver to break the knockout plate out of the chassis. Discard the knockout plate.
8. If the new drive has screws installed on the sides of the drive, remove the screws before inserting
the drive into the chassis.
9. Slide the drive in through the front of the chassis (1) until the bezel on the drive is evenly aligned
with the computer front bezel and install the two M3 metric retainer screws (2) as shown in the
illustration below.
NOTE:
M3 metric retainer screws for optical drives are black. Refer to
on page 24
Figure 2-20
ENWW
Regardless of the power-on state, voltage is always present on the system board as
Removing Bezel Blanks on page 12
Extra drive retainer screws are provided on the interior of the front bezel if needed. The
for an illustration of the retainer screws location.
Installing the Optical Drive
for more information.
Installing Additional Drives
Installing Additional Drives 29