Diskette Drive - Compaq AP400 Maintenance And Service Manual

3-20 Removal and Replacement Procedures

Diskette Drive

Before beginning the removal procedure, make sure there is no diskette in the drive.
NOTE: A standard hard drive in bay 2 can be removed using the same steps used to remove a
diskette drive.
To remove the diskette drive from the drive bay:
1. Perform the service preparations described on page 3-2.
2. Remove the following components:
workstation cover
front bezel
I/O bracket assembly (expansion board bracket)
3. Remove the retaining screws securing the drive cage to the front of the chassis.
NOTE: Depending on your model, you may have 3 or 4 retaining screws.
4. Extend the drive cage slightly from the chassis.
NOTE: It is not necessary to completely remove the drive cage to remove any drives.
Figure 3-20. Extending the drive cage