Chapter 1 Hwping Configuration; Introduction To Hwping; Hwping Configuration; Introduction To Hwping Configuration - H3C S3600 Series Operation Manual

Operation Manual – HWPing
H3C S3600 Series Ethernet Switches-Release 1510

Chapter 1 HWPing Configuration

1.1 Introduction to HWPing

HWPing is a network diagnostic tool used to test the performance of protocols (only
ICMP by far) running on network. It is an enhanced alternative to the ping command.
HWPing test group is a set of HWPing test parameters. A test group contains several
test parameters and is uniquely identified by an administrator name plus a test tag.
You can perform an HWPing test after creating a test group and configuring the test
parameters.
Different from the ping command, HWPing does not display the round trip time (RTT)
and timeout status of each packet on the console terminal in real time. You need to
execute the display hwping command to view the statistic results of your HWPing test
operation. HWPing allows setting the parameters of HWPing test groups and starting
HWPing test operations through network management system.
Switch A Switch A Switch A Switch A
HWPing Client HWPing Client HWPing Client HWPing Client
Figure 1-1 Illustration for HWPin

1.2 HWPing Configuration

1.2.1 Introduction to HWPing Configuration

The configuration tasks for HWPing include:
Enabling HWPing Client
Creating test group
Configuring test parameters
The test parameters that you can configure include:
1) Destination IP address
It is equivalent to the destination IP address in the ping command.
2) Test type
Currently, HWPing supports only one test type: ICMP.
Internet Internet Internet Internet Internet Internet
X.25 X.25 X.25 X.25 X.25 X.25
g
1-1
Chapter 1 HWPing Configuration
Switch B Switch B Switch B Switch B