Table of Contents
Advertisement
Chapter 2: Setting Up the Printer
Repacking the Printer
1.
2.
3.
4.
Choosing a Location
The 7193 is compact and requires little counter space. It may even be mounted on a wall if
space is at a premium. See "Mounting the Printer on a Wall" later in this chapter. The
power supply may also be mounted on a wall or under a table. See "Mounting the Power
Supply on a Wall" later in this chapter. Be sure to plan for the length of the communication
and power cables when choosing a location.
Make sure there is enough room to open the receipt cover and change the paper. The
following illustration shows the actual dimensions of the printer, but leave several inches
around the printer for connecting and accessing the cables.
Setting Switches
A group of switches, called DIP switches, located on the bottom of the 7193, is used for the
following purposes:
6
Protect the printhead by placing a piece of receipt paper between the receipt cover and
the printhead.
Place the printer in the plastic bag and foam pack.
Place the packed printer in the box and secure the box with packing tape.
If you are sending the printer to NCR for repair, call your NCR-authorized service
representative for instructions on where to send the printer.
Be prepared to answer questions concerning shipping and billing.
To set variables for several printer functions (see the sections for the various printer
functions in "Level 1 Diagnostics" in chapter 4)
To set communication parameters for the RS-232C interface or the Parallel interface
(see "RS-232C Switch Settings" or "Parallel Switch Settings" in chapter 5)
To perform diagnostic tests (see the sections for the various diagnostic tests in "Level 1
Diagnostics" in chapter 4)
August 1998
7193 Owner's Guide
Advertisement
Table of Contents
