7167 Owner's Manual
Setting Switches
The DIP switches, located at the back of the printer, are used for three purposes:
•
To set variables for several printer functions (see the sections for the various printer functions in
"Level 1 Diagnostics" in "Chapter 4: Diagnostics" for Setting Up The Printer)
•
To perform diagnostic tests (see the sections for the various diagnostic tests in "Level 1
Diagnostics" in "Chapter 4: Diagnostics" for Setting Up The Printer)
Caution: The DIP switches are set to OFF.
Back of Printer
Bottom
Cover
Note: Switch 1 is shown in the Off position for reference.
Use a paper clip or other pointed object to set the switches.
1. Set the switches to the desired settings shown in the table.
2. Reset the printer.
Printer Reset
The printer is reset by disconnecting/reconnecting the DC power or by opening the slip door and
closing the slip door while holding the receipt paper feed button down.
7
DIP Switch
2
1
ON
Switch 1 is shown in
the OFF position
November 2003
Chapter 3: Solving Problems